51sk4YmJvaL1

GTSUN 5000W peak 15000W pure sine wave inverter combine charger with solar controller, 24volts battery type, AC 220 high power capacity

Model:5.0KW

Inverter Output

Continuous Output Power:5.0KW

Surge Rating(20s):15.0KW

Output Waveform:Pure Sine wave/Same as input(Bypass Mode)

Nominal Efficiency:>88%(Peak)

Line Mode Efficiency:>95%

Nominal Output Voltage rms:220Vac

Output Voltage Regulation:±10% RMS

Output Frequency:50Hz ± 0.3Hz/60Hz ± 0.3Hz

Typical transfer Time:10ms(Max)

DC Input

Nominal Input Voltage:24.0Vdc

Minimum Start Voltage:20.0Vdc

Low Battery Alarm:21.0Vdc / 22.0Vdc

Low Battery Trip :20.0Vdc / 21.0Vdc

High Voltage Alarm:32.0Vdc

Low Battery voltage recover:31.0Vdc

Charger

Charger Breaker Rating:30A

Max Charge Power Rate:1/3 Rating Power

Battery Initial Voltage for Start Up:20-31.4V

Over Charge Protection Shutdown:31.4V

Bypass & Protection

Input Voltage Waveform:Sine wave

Nominal Voltage :220Vac

Nominal Input Frequency:50Hz or 60Hz

Bypass breaker rating :40A

Transfer switch rating:40amp

Max bypass current:40amp

Solar Charger controller

Rated Voltage :24Vdc

Solar Input Voltage Range: 30-55Vdc

Rated Charge Current :60 A

Rated Output Current :15A

Self Consumption :below 10mA

Bulk Charge :29.0V

Floating Charge :27.0V

Equalization Charge :28.0V

Over Charge Disconnection: 29.6V

Over Charge Recovery :27.2V

Over Discharge Disconnection:21.6 V

Over Discharge Reconnection :24.6V

Inverter Dimensions:488*415*200mm

Product Weight KG:50.5

Display:LCD

Product Features

  • Battery Proirity Module or AC Proirity Module, You can choose the two Module according to the switch on the item. this Pure Sine Wave Inverter is a combination of an inverter with charger, LCD and remote control,low freqency inverter, low idle current, very pure sine wave output !
  • Smart Remote Control (RMT) , Battery Temperature Sensor (BTS), Automatic Generator Starting (AGS) ,Support Solar Panel with MPPT Function, Designed to Operate under Harsh Environment
  • DC Start & Automatic Self-Diagnostic Function , Compatible with Both Linear & Non-Linear Load , Easy to Install & Easy to Operate & Easy to Solve , Low DC Voltage Supports Home & Office Appliances , Powerful Charge Rate Up to 120Amp
  • Selectable From 0%-100% , High Efficiency Design & “Power Saving Mode” to Conserve Energy Battery Priority Mode, Designates the Inverter-Preferred UPS Configuration ,13 Vdc Battery Recover Point, Dedicated for Renewable Energy Systems, 8 pre Set Battery Type Selector plus De-sulphation for Totally Flat Batteries
  • 4-step Intelligent Battery Charging, PFC (Power Factor Correction) for Charger , 8 ms Typical Transfer Time Between Utility & Battery, Guarantees Power Continuity, 15s Delay Before Transfer when AC Resumes, Protection for Load when Used with Generator
41Z8lry9SaL

Nature Power 38304 Pure Sine Wave Inverter, 400-watt

The Nature Power 400-Watt Pure Sine Wave Inverters convert 12V DC power into 120V AC power and provides power similar to the power supplied from your home electrical outlets. The Pure Sine Wave inverter, as opposed to the Modified Sine wave inverter, is great for running high sensitive equipment that need ‘clean’ power like computers, monitors, TVs. It will also support high starting power appliances like microwaves and power tools. The electronic appliances are able to run cleaner, cooler and quieter on pure sine wave power. So in return pure sine inverters can save energy costs and extend the life of appliances.

Product Features

  • Provides 400-Watt of continuous power and 800W surge capacity
  • Filtered sine wave output helps eliminates distortion for sensitive electronics
  • 2 AC outlets, 1 5-Volt USB port and On/Off switch
  • Automatic shutoff protects against overload, short-circuit and high and low temperature battery condition
  • Certified to be compliant with safety standards and are ETL listed
51P8rz2ICyL

ZODORE APS Series 3000w / 9000w Pure Sine Wave Inverter Charger with Stabilizer Automatic Voltage Regulator (Avr) 12v/220v, 30kg, High Quality! Inverter/ac Charger/transfer Switch/avr All in One!

Specifications
Model:APS 3000W

Continuous Output Power:3000W
Surge Rating(20s):9000W
Output Waveform:Pure Sine wave/Same as input(Bypass mode)
Nominal Efficiency:>88%(Peak)
Line Mode Efficiency:>95%
Power Factor:0.9-1.0
Nominal Output Voltage rms:220-230-240V
Output Voltage Regulation:¡À10% RMS
Output Frequency:50Hz¡À0.3Hz/60Hz¡À0.3Hz
Short Circuit Protection:Yes(10s after fault)
Typical transfer Time:10ms(Max)
THD: DC Input
Nominal Input Voltage:12V (*2 for 24V,*4 for 48V)
Minimum Start Voltage:10Vdc
Low Battery Alarm:10.5V/11.0Vdc
Low Battery Trip:10.0V/10.5Vdc
High Voltage Alarm:16.0Vdc
Low Battery voltage recover:15.5V
Idle Consumption-Search Mode:

Product Features

  • INTRODUCTION: 1. APS Pure Sine Wave Inverter/Charger is a combination of APC inverter and Automatic voltage regulator. 2. Connected with batteries, the APS inverter will function as a UPS with max transfer time of 10ms. 11. With all the unique features from the inverter and AVR, it brings you long-term trouble free operation beyond your expectation.
  • APS IVERTER/ AVR FEATURES: On Inverter: 1. High overload ability up to 300% rated power(20 sec.); 2. Low voltage trip selectable (9.5V/10V or 10V/10.5V), extracting max. power from various batteries with different protections; 3. Low quiescent current, power saver mode to reduce power consumption to 10W (3s sensing cycle)/ 3W (30s sensing cycle)* ; 4. 13VDC battery recover point, dedicated for solar systems. On AVR: 1. Wide stabilizing AC range ; 2. Bucking/Boosting voltage in 10ms.
  • On Battery charger: 1. 3-step intelligent battery charging; 2. 8 pre set battery type selector plus de-sulphation for totally flat batteries; 3. Powerful charge rate up to 90Amp**, selectable from 0%-100%.; 4.PFC(power factor correction) for charger, less power consumption than conventional units.
  • On Transfer: 1.10ms typical transfer time between battery and AC, guarantees power continuity; 2. 15s delay before transfer when AC resumes, extra protection for loads when used with generator; 3. Input AC voltage range selectable (184-253V or 154-253V), for different kinds of loads; 4. 30A/40A through current ability ; 5. Allows start up and through power with depleted batteries.
  • On Remote Control & Other Features: 1. Ability to switch the unit on/off, select/deselect power saver mode 17 alarms/warning, informative for easier operation and trouble-shooting; 2. LCD status display available; 3. Battery/AC priority swith available for off grid solar/ wind system; 4. USB communication port available; 5. Input Voltage 12v/24v/48v to 110 /220 for your choice, just leave a message which style you want! Note:*For 1KW one. **For some models.
41wTdVvtqXL

Tripp Lite PDUMH30ATNET PDU Switched ATS 120V 30A 24 5-15/20R, 1 L5-30R 2 L5-30P 2URM

PDUMH30ATNET 2U horizontal rack mount Auto Transfer Switch/ATS offers 30A 120V multi-outlet power distribution with dual input connections, individually switched outlets, built-in network interface and digital current metering. Includes separate L5-30P primary and secondary input cords and 25 switched output receptacles. Built-in network interface enables remote SNMP/Web monitoring and control. Remotely displays status of input power, load level and outlet power status via secure network or web browser interface. Supports optional environmental and contact-closure sensor options. Offers programmable or real-time individual outlet control to power on, off, or cycle AC output to regain control of locked-up servers and other network devices.

Product Features

  • ATS functionality is available with any two compatible AC power sources, even configurations utilizing separate mains circuits, backup generators and even separate utility power grid feeds are fully supported, regardless of phase angle
  • Connected equipment is normally powered from the primary input; ATS circuit provides automatic transfer to the secondary power source input within 3-6 milliseconds if primary input power is interrupted
  • 25 switched output receptacles (24 5-15/20R & 1 L5-30R)
  • Separate primary and secondary L5-30P inputs, each with 10 ft./3m line cord
  • 120V 30A Auto Transfer Switch/ATS in 2U horizontal rack mount installation format (agency de-rated to 24A continuous)
51PwZQdk1RL

Topscreen2012(TM)~~Diesel Generator Part AVR EA15A Universal Automatic Voltage Regulator

Shipping detail
This listing item shipping from China
Item will be shipped 1-2 working days after full payment is received.
usually it will take 7-15 working day to reach USA, will take longer time to outside US Countries. (please view shipping rates and policies part)
We only ship to the comfirmed address given on Amazon. Please make sure the address is correct.

If you have any problem of the product, please contact us winthin 7 day after you receive the parcel.
Unwanted product returns will be subject to a 15% restocking fee and merchandise must be in the unused condition only.
Due to the profit low,return shipping fee will be charge by buyer

Please do not open the A-to-Z claim or leave 1-3 stars before contacting us. any questions, please feel free to let us know. we will reply any questions within 24 working hours.
working time: Monday to Friday (9:00-18:00)–Chinese time
Sunday to Friday (17:00-2:00)–US time

Product Features

  • Voltage Regulation < ±0.5%
  • 220/380/440/480 VAC Input Voltage Sensing
  • 3 Phase Sensing
  • Dimensions 150.0 (L) x 135.0 (W) x 72.0 (H) mm
  • Weight 867 g ±2%

The Automatic Generator Site